Part Number Hot Search : 
P4202 SM6150S 1100A 1R1001 AX125 12018 LSP10480 2SD560MB
Product Description
Full Text Search
 

To Download EGOV3S3-1944M Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. HTTP://WWW.CONWIN.COM
PRODUCT
DATA
SHEET
CRYSTAL CONTROLLED OSCILLATORS
14 PIN DIP 3.3V HCMOS STRATUM 3 OCVCXO
ABSOLUTE MAXIMUM RATINGS
PARAMETER Storage Temperature Supply Voltage Control Voltage (Vcc) (Vc) UNITS MINIMUM -40 -0.5 -0.5 NOMINAL MAXIMUM 85 4.5 4.5 UNITS C Vdc Vdc TABLE 2.0 (Fo) MINIMUM 1.544 -1.5 -0.25 -30 -2.5 -4.6 0 (Vcc) (Icc) 3.135 3.3 -90 -135 NOMINAL MAXIMUM 20.0 1.5 0.25 30 2.5 4.6 70 3.465 450 1 3 5 10 5 1 2 UNITS MHz ppm ppm ppb ppm ppm C Vdc mA ps rms ps rms ps rms dBc/Hz dBc/Hz mS Minutes nS nS 1,3 2 3 4 NOTE TABLE 1.0 NOTE
CW 0107 EGOV3S3 19.44M
OPERATING SPECIFICATIONS
PARAMETER Center Frequency Frequency Calibration Frequency Stability Aging (Daily) Aging (20 Years) Total Frequency Tolerance Operating Temperature Range Supply Voltage Supply Current Phase Jitter (BW=12KHz to 20MHz) Phase Jitter (BW=10Hz to 20MHz) Period Jitter SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Start Up Time: Oscillator Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec.
EGOV3S3
DESCRIPTION
5
The Connor-Winfield EGOV3S3 is a hermetically sealed 14 Pin DIP, 3.3V Oven Controlled Voltage Controlled Crystal Oscillator (OCVCXO) with an HCMOS/TTL compatible output. The EGOV3S3 is designed for higher stability Stratum 3 applications requiring low jitter and tight frequency stability.
INTPUT CHARACTERISTICS
PARAMETER Control Voltage Range Frequency at Vc=0.3 Vdc Frequency at Vc=3.0 Vdc Slope of Frequency Adjust Input Impedance (Vc) MINIMUM 0.3 -22.5 13.5 5 100k NOMINAL 1.48 MAXIMUM 3.0 -13.5 22.5 UNITS Vdc ppm ppm ppm/V Ohm
TABLE 3.0 NOTE
FEATURES
6
3.3V OPERATION LOW JITTER <1pS RMS FREQUENCY STABILITY: 0.25ppm
HCMOS OUTPUT CHARACTERISTICS
PARAMETER LOAD Voltage (High) (Low) Current (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% MINIMUM 2.6 -4 45 50 NOMINAL MAXIMUM 15 0.4 4 55 6 UNITS pf Vdc Vdc mA mA % nS
TABLE 4.0 NOTE
TEMPERATURE RANGE: 0 to 70C FREQUENCY TOLERANCE OF 4.6ppm OVER TWENTY YEARS HERMETICALLY SEALED PACKAGE
(Voh) (Vol) (Ioh) (Iol)
PACKAGE CHARACTERISTICS
Package
Notes: 1) 2) 3) 4)
TABLE 5.0 14 pin DIP, hermetically sealed, grounded case, welded package
ORDERING INFORMATION
Initial calibration @ 25C, Vc=1.48 Frequency vs. temperature stability At the time of shipment after48 hours of operation. Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration, 20 years aging, Vc=1.48. 5) Measured @ 25C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of co ntinuous operation at a stable 25C 6) Referenced to Fo @ 25C, Positive Transfer Characteristic
EGOV3S3
OCXO SERIES
- 19.44MHz
CENTER FREQUENCY
Specifications subject to change without notice. DATA SHEET #: Cx050 PAGE 1 OF
2
REV: 00
DATE:
3/19/03
aCopyright 2001 Connor-Winfield all rights reserved.
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722.
PRODUCT
D ATA
SHEET
CRYSTAL CONTROLLED OSCILLATORS
ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55C to 125C, 20 cycles,10 minute dwell, 1m inute transition. Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125C 5C for 20 seconds. SOLDERING Pin Solderability: Per MIL-STD-883, Method 200. 8 hour steam age prior to 254C 5C Solder pot dip, 95% Coverage. Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside board -mount product, 260C 5C for 20 Seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G's peak, 10Hz to 500Hz, 15mi nute cycles 12 times each perpendicular axis. Shock: Per MIL-STD-202, Method 213, Condition D. 500G's, 1ms, half sine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65C, 10 cycles 10C to 65C.
.330 MAX (8.38mm)
CONTROL VOLTAGE
+3.3Vdc
CONTROL VOLTAGE
Specifications subject to change without notice. DATA SHEET #: Cx050 PAGE 2 OF
2
REV: 00
DATE:
3/19/03
aCopyright 2001 Connor-Winfield all rights reserved.


▲Up To Search▲   

 
Price & Availability of EGOV3S3-1944M

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X